Your military JD cannot work, AFAIK, because your ship is bigger, than her military JD max ship size.It just doesn't work? Even when trying to tender for small enough military ships?
Your military JD cannot work, AFAIK, because your ship is bigger, than her military JD max ship size.
It just doesn't work? Even when trying to tender for small enough military ships?I have just tried this. I have used SM, unlocked the Gatebuilder and replaced the 15k military jump drive with 45k one. Limeleaf was still unable to jump.
I have just tried this. I have used SM, unlocked the Gatebuilder and replaced the 15k military jump drive with 45k one. Limeleaf was still unable to jump.
What was the final size of the Gatebuilder? 15k to 45k jump drive is a fairly big increase. If the new size of the Gatebuilder is over 45k, you are still stuck.Exactly 45k. The original version was at efficiency 6, now I am at 10 so I was moving from 50 HS only to 90 HS. I removed like one layer of armor and one CIWS so I could fit that SMed 45k military jump drive.
Exactly 45k. The original version was at efficiency 6, now I am at 10 so I was moving from 50 HS only to 90 HS. I removed like one layer of armor and one CIWS so I could fit that SMed 45k military jump drive.And you still had that other Military Drive on the design? Because I know THAT causes some problems.
And you still had that other Military Drive on the design? Because I know THAT causes some problems."I was moving from 50 HS only to 90 HS" meant I have removed the 15k one and put in 45k one. I have SMed the new drive, put it into Gatekeepers, tried to jump and then reloaded the save. I didn't store the updated design.
Once you updated the design, did you open the ship in the ship viewer? This forces the software to load the new design instead of the old design staying in the buffers.Thanks for the tip. I am not sure about the first time but I have now tried multiple times to use Gatekeeper to tender for Zahringen, 5.4 kt light troop transport with mil engines. I have changed the jump drive configuration in Gatekeeper, used deployment time and armor to get it exactly to 45 kt and loaded it in Individual ship view to check the new amount of armor.
Your results make no sense. You have a 45kt jump tender, with a 5.4 kt mil jump engine, it can't jump a 5.4 kt ship as it can't jump itself. So your first config 1 should never work as the engine's jump capacity is below the size of the ship mounting it.Why should not there be a jump tender that is unable to jump itself but allows jumping for smaller ships? You just park it on your side of JP and smaller ships can go back and forth...