« previous next »
Pages: [1]   Go Down

Author Topic: slow missile overflow error.  (Read 1327 times)

0 Members and 1 Guest are viewing this topic.

Offline se5a (OP)

  • Lt. Commander
  • ********
  • Posts: 288
  • Thanked: 30 times
slow missile overflow error.
« on: July 05, 2014, 12:23:18 AM »
so I designed a missile for a PDC to attack stationary targets at another enemy planet in the system, I fired one of these at a ship just to see what would happen (it has faster submunitions with sensors)

however I get
Error in CheckMissileInerceptions
Error 6 was generated by Aurora
Overflow

every 5 seconds.
I looked around to see if there was a way I could either destroy the missile, or the enemy ship in SM mode just to allow me to continue playing, but I'm not seeing anything. I'm pretty sure I've seen mention of killing enemies with SM mode, but I'm not seeing it.

also, is there any decent threads that explain how to properly design missiles with warheads, and sensors?
Report to moderator   Logged
 

Offline chrislocke2000

  • Captain
  • **********
  • c
  • Posts: 544
  • Thanked: 39 times
Re: slow missile overflow error.
« Reply #1 on: July 05, 2014, 05:44:56 PM »
You can destroy a missile through the missile salvo tab on the weapon control screen.
Report to moderator   Logged
 

Offline se5a (OP)

  • Lt. Commander
  • ********
  • Posts: 288
  • Thanked: 30 times
Re: slow missile overflow error.
« Reply #2 on: July 05, 2014, 06:13:56 PM »
...I totally looked at that screen a couple of times for this and didn't see those two buttons.
I'm an idiot.
Thanks.
Report to moderator   Logged
 
Pages: [1]   Go Up
« previous next »