Author Topic: Automines On Halle Bopp  (Read 1065 times)

0 Members and 1 Guest are viewing this topic.

Offline undercovergeek (OP)

  • Sub-Lieutenant
  • ******
  • u
  • Posts: 128
  • Thanked: 4 times
Automines On Halle Bopp
« on: December 16, 2023, 07:12:59 AM »
Just asking for a spot of advice, have found some much need Neutronium on Halle Bop, have managed to get a mass driver on there and i am in the process of delivering automines, very slowly

I have 2 on there but no packet has been sent yet - is there a minimum number of mines before the comet starts sending the goodies?
 

Offline Zap0

  • Captain
  • **********
  • Posts: 410
  • Thanked: 509 times
Re: Automines On Halle Bopp
« Reply #1 on: December 16, 2023, 08:23:48 AM »
No. Did you set the destination in the mining window on the comet? And does Earth have another mass driver to receive?
 

Offline undercovergeek (OP)

  • Sub-Lieutenant
  • ******
  • u
  • Posts: 128
  • Thanked: 4 times
Re: Automines On Halle Bopp
« Reply #2 on: December 16, 2023, 08:48:08 AM »
Set destination earth

Does earth not start with a mass driver in c#?

I suppose even if I didn’t have one on earth I’d see the packets on their way?

I’ll check there’s a destination again
 

Offline Ulzgoroth

  • Captain
  • **********
  • U
  • Posts: 423
  • Thanked: 73 times
Re: Automines On Halle Bopp
« Reply #3 on: December 16, 2023, 02:41:57 PM »
Are you just not seeing packets or are you also not seeing minerals being deducted from the mining colony inventory?

I believe you have to specifically switch on a display setting to be able to see mass driver packets.
 
The following users thanked this post: undercovergeek

Offline Black

  • Gold Supporter
  • Rear Admiral
  • *****
  • B
  • Posts: 872
  • Thanked: 219 times
  • 2024 Supporter 2024 Supporter : Supporter of the forum for 2024
    2020 Supporter 2020 Supporter :
    2023 Supporter 2023 Supporter : Supporter of the forum in 2023
    2021 Supporter 2021 Supporter :
Re: Automines On Halle Bopp
« Reply #4 on: December 16, 2023, 04:02:43 PM »
Only bodies with mass driver present can be selected as Mass Driver Destination in Mining tab. So if Earth has no mass driver, it cannot be selected.

Do you have Mineral Packet checkbox checked? Packets are not visible by default. You need to check the box to see them: Left side menu in system view - Display tab - Mineral Packets.

 
The following users thanked this post: undercovergeek

Offline paolot

  • Lieutenant
  • *******
  • p
  • Posts: 164
  • Thanked: 25 times
Re: Automines On Halle Bopp
« Reply #5 on: December 16, 2023, 06:02:43 PM »
Just asking for a spot of advice, have found some much need Neutronium on Halle Bop, have managed to get a mass driver on there and i am in the process of delivering automines, very slowly

I have 2 on there but no packet has been sent yet - is there a minimum number of mines before the comet starts sending the goodies?

I don't understand: had you any mines on the comet, when mass drivers were installed? so, are minerals mined/stored on the comet?
A mass driver can send minerals only if at least one mine is active on the body.
« Last Edit: December 16, 2023, 06:04:20 PM by paolot »
 
The following users thanked this post: undercovergeek

Offline undercovergeek (OP)

  • Sub-Lieutenant
  • ******
  • u
  • Posts: 128
  • Thanked: 4 times
Re: Automines On Halle Bopp
« Reply #6 on: December 17, 2023, 03:16:47 AM »
came back to say thankyou for everyones advice

it would appear i hadnt switched packets on in the display - the shame, now on, minerals flying all over the place