Posted by: TMaekler
« on: May 13, 2020, 04:01:17 AM »Yes, basically an engine and a pod for ground support. Not battle tested yet...
So, I have a shipyard now which is tooled for the new fighter class. I can scrap the old ones in it, but if I want to refit, the old class isn't shown. Any ideas, why? If I set the class to obsolete or not doesn't change it. It isn't shown in either case.
Ship sizes are 48t for the old one and 34t for the new, and the shipyard has 500t and 2 slipways. So should fit ;-)
So, I have a shipyard now which is tooled for the new fighter class. I can scrap the old ones in it, but if I want to refit, the old class isn't shown. Any ideas, why? If I set the class to obsolete or not doesn't change it. It isn't shown in either case.
Ship sizes are 48t for the old one and 34t for the new, and the shipyard has 500t and 2 slipways. So should fit ;-)
Those two designs are most likely too different to allow refit. There is the 20% refit range of the target design rule that would apply in this situation.
So, I have a shipyard now which is tooled for the new fighter class. I can scrap the old ones in it, but if I want to refit, the old class isn't shown. Any ideas, why? If I set the class to obsolete or not doesn't change it. It isn't shown in either case.
Ship sizes are 48t for the old one and 34t for the new, and the shipyard has 500t and 2 slipways. So should fit ;-)
You can refit from ship A to ship B as long as B is within 20% of the size of ship A.
So, I have a shipyard now which is tooled for the new fighter class. I can scrap the old ones in it, but if I want to refit, the old class isn't shown. Any ideas, why? If I set the class to obsolete or not doesn't change it. It isn't shown in either case.
Ship sizes are 48t for the old one and 34t for the new, and the shipyard has 500t and 2 slipways. So should fit ;-)
Never heard of that rule before. Where can I find a posting about it?
So, I have a shipyard now which is tooled for the new fighter class. I can scrap the old ones in it, but if I want to refit, the old class isn't shown. Any ideas, why? If I set the class to obsolete or not doesn't change it. It isn't shown in either case.
Ship sizes are 48t for the old one and 34t for the new, and the shipyard has 500t and 2 slipways. So should fit ;-)
I thought I remembered that fighters could be refitted now. But they either can't or I don't find how.
Anyone?
I believe you would have to have a shipyard tooled for the target design (or tooled for another design within the 20% refit range of the target design).
I thought I remembered that fighters could be refitted now. But they either can't or I don't find how.
Anyone?